ConverterHub

Slope / Grade Calculator

How do I calculate slope?

Result

8.33%
4.76°
1:12.00

How it is calculated

Slope is expressed three ways from the vertical rise and horizontal run: grade = rise / run × 100, angle = arctan(rise / run) in degrees, and ratio = 1 : (run / rise). Rise and run must use the same unit. The run must be greater than zero, because it is the horizontal distance and not the length of the sloping surface. A negative rise means a downhill slope and gives a negative grade and angle, while the ratio is shown as an absolute value. If the rise is zero the slope is flat and the ratio is shown as a dash. Note that a 100% grade is 45°, not 90°, because the grade grows without limit as the slope approaches vertical.

Worked example

A ramp climbs 1 unit over a horizontal run of 12 units. Grade = 1 / 12 × 100 = 8.33%. Angle = arctan(0.0833) ≈ 4.76°. Ratio = 1 : (12 / 1) = 1:12.00. All three values describe the same incline.

Try this example →

Common mistakes

  • Measuring along the sloping surface as the run instead of the horizontal distance.
  • Using different units for rise and run, such as rise in centimetres and run in metres.
  • Believing that a 100% grade is vertical; it is a 45° incline.
  • Reading a 1:12 ratio as 1/12 of an angle or as 12%, instead of about 8.33%.
  • Forgetting the sign: a negative rise is a descent and the grade and angle are negative.

About this calculator

This calculator turns a vertical rise and horizontal run into three equivalent ways of expressing slope: a percentage grade (rise divided by run, times 100), an angle in degrees (the arctangent of rise over run), and a simplified ratio. The three describe the exact same incline, but different fields default to different units, so being able to convert between them on demand avoids a lot of confusion.

Road signs and cycling apps typically show grade as a percentage, construction and engineering drawings often specify slope as a ratio (like 1:12 for a wheelchair ramp) or in degrees, and hikers comparing trail steepness may see either. Builders use it to check that a ramp, roof or drainage slope meets a code requirement expressed in a different unit than the one they measured on site.

Was this helpful?

You can pick up to 3 reactions.

Comments (0)

  • Be the first to comment.

Popular calculators

Loan Calculator

Monthly payment, total interest and full amortization schedule.

Percentage Calculator

Percent change, percent of, and ratio calculations.

Discount Calculator

Calculate final price, savings, and discount amount.

BMI Calculator

Body mass index from height and weight (metric or imperial).

Age Calculator

Compute your exact age in years, months and days from a birth date.

Compound Interest Calculator

Calculate the final amount and interest earned with compounding.

All Calculators